2022 GMC Canyon problems

“Could not turn the ignition key off beyond the Accessory position in order to turn the key completely off to remove the ignition key. The key would stick in the ON oor Accessory position. The problem was in the microswitch button on the console shifter, the front button is pushed in to enable shifting into the PARK position. This is a safety concern due to not being able to turn off the ignition and also to not remove the key from the ignition. The repair was done by the dealer, a control unit in the shifter was replaced to correct the problem. Part cost was $525, labor was $225.73. This is a class problem on Chevrolet Colorado and GMC Canyon trucks. There should be a recall on this problem.”

“After driving vehicle and parking vehicle turn key off key will not turn all the way off to pull key out of ignition switch. The vehicle had 35,750 miles when brought to dealership I had told them this has happened multiple times I had to restart vehicle move vehicle shift vehicle manually or drive around block park again and then key would turn all the way off and come out, When I was contacted from the GMC dealership they said they could not duplicate the problem but I have paperwork from them and the mileage during drop off which was 35,750 miles and pickup at 35,751 miles I also told them to drive the truck it is not going to happen sitting in the dealership parking lot but they only went 1 mile, The warranty for this problem will be up at 36,000 miles. I drove the vehicle 8 miles from the dealership to my house no problems drove another drove another 6 miles to the car wash and went through the car wash went to park to vacuum and wipe exterior the key would not turn all the way off stuck in the accessory position had to back up and move vehicle to another spot park and then the key turned all the way off so I could get key out”

“The ignition key gets stuck in the ignition after shutting off the car. The key may not be removed from the ignition. The failure of the transmission shift control mechanism directly impacts the safe, mechanical operation of the vehicle's powertrain and transmission park-lock functions. The vehicle was taken to a local GM dealer and the problem was recreated. This is a known problem with the transmission shift control assembly for several model years (2020 - 2023). Also, there was a previous class action lawsuit (Jefferson & Riley class action settlement) which specifically covered a predefined list of early-generation model years (including the 2017–2019 GMC Acadia, 2019 Chevy Blazer, and 2016–2019 Malibu/Traverse/Volt). GM continued using similar microswitch shifters in newer vehicles like your my 2022 Canyon. I had no prior warning lamps but the symptoms occurred infrequently after I purchased the vehicle on March 29, 2023. I am the original owner of the vehicle and in July 2026 the problem became frequent - on an almost daily basis. I took the vehicle to my local GM dealer and I was initially told to use my spare key and see if that fixes it. In August…”

“The ECU electric control model has now burned up 3 times and the dealership just keeps replacing it the only thing they keep saying not to fill up the gas tank all the way? The gas gauge just goes dead”

“At various times key can not be removed from the ignition. I understand this to be a common problem on these trucks, but dealer does not agree.”

“To Whom It May Concern, This letter is submitted to report a safety-related defect involving an airbag sensor failure on a 2022 GMC Canyon. The vehicle experienced a failure of an airbag sensor that is part of the Supplemental Restraint System (SRS). The sensor is required for proper airbag deployment and system readiness. Failure of this component compromises the operation of the airbag system and presents a potential safety risk to vehicle occupants. The failure occurred on a vehicle approximately four years in service and was diagnosed as an airbag sensor defect. The sensor assembly includes an integral gasket, and the failure of that gasket resulted in sensor malfunction and airbag system fault indications. General Motors and the administrator of the GMC Platinum Protection Plan were notified of the defect. Coverage for the repair was refused on the basis that a component of the sensor assembly was allegedly excluded, despite the fact that the gasket is integral to the sensor and the failure affects a federally regulated safety system. As a result of this refusal, a safety-related defect involving an airbag system was not repaired. The matter was treated as…”