2017 Mercedes-Benz Metris problems

“The contact owns a 2017 Mercedes-Benz Metris. The contact received notification of NHTSA Campaign Number: 22V482000 (Tires); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.”

“I am filing a formal safety complaint regarding my Mercedes-Benz Metris serviced at Mercedes-Benz Coconut Creek (Florida) under Recall VS2LAS561 – 9789VMCRC (Customer Service Case #20781216). On February 12th, I delivered the vehicle for recall service. It was returned on February 23rd without the recall properly completed. Invoice no. 328897 – tag T9514 lists replacement of four Continental 235/55 R17 tires and installation of four PRS sensor repair kits. These items were not installed. The tires were placed in the trunk, and only three used sensors are present; one wheel has no sensor. Additionally, the dealership provided 235/55 R17 tires, while the vehicle is homologated for 225/55 R17. Supplying non-approved tire sizes represents a safety concern. Since purchase (from the same dealership), I have reported tire pressure irregularities and abnormal lateral tire wear. During the most recent service, no tire rotation was performed despite documented uneven wear. Two weeks prior to the recall visit, I experienced a highway tire blowout while traveling with my family. When attempting to install the spare tire, I discovered the wheel lock removal key had been…”

“Safety inspection of tires are showing abnormal and rapid tread wear focused on the outside facing section of tread on all four tires. While the section of tread on the inside facing section is near factory new. The vehicle was bought factory new and this is on the original set of tires. Mileage at this time is still below 25,000 as it is driven sparingly. Despite that All four corners exhibit rapid and uneven wear of the tread indicating an alignment issue from the factory. The vehicle has never been in any colision nor curbed even once. Owner research on various Metris forums show this is not an isolated issue. Many point to an error in factory parameters regarding camber as well as a excessive toe in.”

“The contact owns a 2017 Mercedes Benz Metris. The contact received notification of NHTSA Campaign Number: 22V099000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The dealer had been notified of the issue and confirmed that parts were not yet available. The manufacturer had been notified of the issue. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact had not experienced a failure. Parts distribution disconnect.”

“I have had 2 major and costly repairs/issues with the engine and its oil system. These are detailed below. I have also received multiple collision or seatbelt dash alerts when no one is near my vehicle whatsoever. Unexpected repairs back-to-back due to defective parts/design: Oil pump control valve and harness replaced. Cost: $1,499. Replaced crankcase ventilation hose assembly. Cost: $3,293.37”

“Vehicle experienced Crankcase ventilation component failure at low miles of 31,750. Code thrown is P052E resulting in needing replacement of a large assembly of emissions/oil vapor control tubing and valves costing over $1000 plus over 12 hours of labor. Well known problem on Mercedes vehicles with the M274 2.0 turbo 4cylinder engine.”