2016 Ram 1500 service brakes problems

“ABS Control Module stopped working ,leaving traction control and anti lock brakes inoperable. Parts are not available from dealers or after market manufacturers. This has been an on going problem with multiple year vehicles.”

“ABS and Brake lights on dash since October of 2024. No module available from any MOPAR source for a year. Had accident in July 2025. Truck slid as ABS did not engage which was direct cause of the accident resulting in damage to both vehicles. I have followed up monthly as to the availably and they continue to be on backorder and for a year it was showing Stellantis was investigating issue. Apparently this has been an ongoing safety issue that has not been address as a recall.”

“The ABS module has failed. This ABS module failure is producing the following codes: The failure code in the ABS module is C2200–49 indicating a internal module failure when the ABS module goes off-line it sets communication codes in other modules, causing the transmission module to go into limp mode. This has been confirmed by an independent service center. There are multiple warning lights on the dashboard including the ABS light, the traction light, and the brake light. This failure is causing multiple failure codes and no communication within the engine. Please see attached pictures and documentation from garage.”

“The ABS warning light,electronic stability/traction control warning light, and red Brake warning light are illuminated simultaneously on the instrument cluster. The combination of these warning lights concerns me because it appears to indicate a failure or malfunction involving the ABS/brake-control system. I am concerned that ABS, electronic stability control, and traction control functions may not operate properly during an emergency breaking or loss-of-traction event. I understand that owners of 2016 1500 vehicles have reported similar combinations of ABS, traction control ,and brake warning lights and have reported ABS-module failures. I am requesting that NHTSA document and investigate this condition as a potential safety defect affecting 2016 Ram 1500 vehicles. I would like this complaint associated with my VIN and mileagefor purposes of identifying any trend involving ABS-module or brake-system failures. I have photographs showing the warning lights illuminated on my vehicle.”

“ABS Contol module failure, highly known and documented issue with the ram 1500's. Mine is a 2016 with the 5.7L. Showing ABS code C2200-49. Parts are no where to be found and it is now impossible to have the module rebuilt due to Chrysler no longer producing the hardware. I have a very expensive paper weight sitting in my driveway!”

“Anti-Lock Brake Module Internal Failure - Code C2200-49 The truck ABS does not work, tractions control is disabled, and Cruise Control does not work. There were no lights or warning until the day I went to start the vehicle and then the abs, traction control, and brake light came on and stayed on once the truck was started. With researching this issue, it seems to be a widely known issue for several year trucks and parts to repair the ABS module are no made any longer. Calling the dealer the replacement part, which from what I read has been redesigned and is on an unknown backorder timeline. The cost for the part and labor is very high. From what I have read there was a TSB/Recall on some 2017 and newer ram trucks. I have not been able to determine if this is the same ABS module that is being used for the replacements in the older rams trucks. The truck without ABS and traction control is dangerous. I was on the highway and traffic came to an abrupt stop and when I applied the brakes my rear tires started to lock up. Luckily I am a defensive natured driver and was able to keep control of the vehicle and adjust my braking pressure and move towards the burm of…”