P0248Powertrain · Fuel & airGeneric (SAE) code

P0248: Turbocharger Wastegate Solenoid B High

The control circuit for wastegate solenoid B reports a voltage above the expected range. Typical causes are a short to power or an open ground.

Typical labor cost
$65–$315 est.
30 min–2.5 h at an assumed $125/hr · parts extra · use your rate
Most common fix
Wastegate solenoid B defective
DIY difficulty: Moderate · usually a shop job
01 —What it means

What P0248 means

P0248 is a generic OBD-II powertrain code in the fuel & air group.

P
Powertrain
0
Generic (SAE)
2
Subsystem group
48
Specific fault
How to read P0248. We group it under Fuel & air.
Check engine light
Usually on
Emissions-related
Yes — can fail inspection
Limp mode possible
Yes
Drive cycle to clear
Not required
Code data: OBDex (CC0)

Get it fixed

Post this code once and get quotes from local mechanics. Free to post.

Your car Optional

Makes the repair and parts links below specific to your car. Kept in this browser only.

Get quotes on findmechanic.ai (opens in a new tab)
02 —Symptoms

Symptoms

What drivers typically notice
  • Check engine light on
  • Significant power loss / limp mode
  • Possible blue or black smoke from exhaust
  • Whistling or hissing sound from intake
Code data: OBDex (CC0)
03 —Causes

Common causes

Ranked from most to least likely
  1. 01Wastegate solenoid B defectiveMost likely
  2. 02Wiring shorted to powerPossible
  3. 03Ground circuit openLess likely
Code data: OBDex (CC0)
04 —Severity

Can I drive with P0248?

Urgent

Not recommended beyond getting it to a shop.

This fault can put the engine or transmission in limp mode with reduced power, which can make merging and passing unsafe. Have it diagnosed as soon as possible.

Why we rate it urgent

  • Can put the vehicle in limp mode (reduced power)
  • Turns on the check engine light
  • Emissions-related: will usually fail an OBD inspection

Severity is our rule-based rating from the code’s flags in OBDex and the system it affects, not an inspection of your car. If the check engine light is flashing, or you notice overheating, low oil pressure, or brake or steering problems, stop driving and get help.

Code data: OBDex (CC0)
05 —Diagnosis

How to diagnose P0248

General procedure — follow the service manual for your vehicle
  1. 1

    Confirm the code and save freeze-frame data

    Read the codes with an OBD-II scan tool and note every code, not just P0248. Save the freeze-frame data (speed, load, temperature when the fault set) before clearing anything; it tells you when the fault happens.

  2. 2

    Check for related codes first

    Look for P0245, P0246, P0247. Related codes often share a cause; a circuit or sensor code usually needs fixing before a performance code like this one.

  3. 3

    Test the circuit

    Inspect the wiring and connector at the wastegate solenoid and turbocharger for damage, corrosion or chafing. With a multimeter, check supply voltage, ground and signal against the specifications in the service manual for your vehicle.

  4. 4

    Test the likely causes in order

    Start with the most likely cause and work down: Wastegate solenoid B defective; wiring shorted to power; ground circuit open. Test before replacing parts.

  5. 5

    Check for recalls and service bulletins

    Look up recalls for your exact vehicle with its VIN, and ask a dealer about technical service bulletins (TSBs). Manufacturers sometimes issue software updates or extended warranties for known faults.

  6. 6

    Clear the code and verify the repair

    After the repair, clear the code and drive the car under the conditions in the freeze-frame data to confirm it does not return.

Code data: OBDex (CC0)
06 —Cost

P0248 repair cost estimate

Labor only — set your local shop rate
Labor estimate for P0248
$65–$315
30 min–2.5 h of labor × $125/hr (assumed rate) · parts extra

Estimate, not a quote. Labor times are typical ranges for this code from OBDex, and $125/hr is an assumed rate. Shop rates and labor times vary by vehicle and region. Diagnosis time may be billed separately.

DIY difficulty
Moderate
Good DIY job?
Usually a shop job

Needs a scan tool and some experience with testing.

Code data: OBDex (CC0)
07 —Components

Parts and systems involved

  • Wastegate solenoid
  • Turbocharger
  • Solenoid wiring
Code data: OBDex (CC0)
09 —FAQ

P0248 FAQ

What does P0248 mean?

P0248 means “Turbocharger Wastegate Solenoid B High”. The control circuit for wastegate solenoid B reports a voltage above the expected range. Typical causes are a short to power or an open ground.

Is P0248 serious? Can I keep driving?

We rate P0248 as urgent severity. Not recommended beyond getting it to a shop. This fault can put the engine or transmission in limp mode with reduced power, which can make merging and passing unsafe. Have it diagnosed as soon as possible.

What causes P0248?

The most common causes, from most to least likely: Wastegate solenoid B defective; Wiring shorted to power; Ground circuit open. Test before replacing parts, because several causes can set the same code.

How much does it cost to fix P0248?

Typical labor is about $65–$315 at an assumed $125/hour shop rate, plus parts. That is an estimate, not a quote: labor times and rates vary by vehicle and region, and diagnosis may be billed separately.

Can I fix P0248 myself?

DIY difficulty is moderate. Most owners leave this to a shop because it needs involved testing or specialist tools. Always confirm the cause before buying parts.

Will P0248 clear itself?

If the fault was intermittent, the warning may go off once the computer stops seeing it, but the code stays in memory. Fix the cause; clearing the code alone doesn’t repair anything.

Code data: OBDex (CC0)