2016 Ford Focus fuel/propulsion system problems

“The vehicle was brought to a certified Ford dealership for an active safety recall and manufacturer extended warranty repair. Due to a malfunction related to the recall issue, the fuel lines were completely ripped off the fuel tank. This component failure is currently available for inspection on the dealership's lot. This failure created an immediate, severe safety risk. Severed fuel lines present an active fuel leak, toxic vapor release, and an extreme fire/explosion hazard in a public dealership parking lot. The physical damage was personally inspected and photographed by me on the dealer's lot. However, the dealership service center is actively refusing to execute the safety recall remedy or fix the severed fuel lines unless I pay out-of-pocket for an unrelated, standard maintenance battery replacement. Furthermore, the dealership provided a multi-point inspection report falsely marking the vehicle status as "all green" despite the severed fuel lines, and they have intentionally withheld the true condition of the vehicle and the required repair orders from the manufacturer's corporate tracking database.”

“The vehicle is subject to NHTSA Safety Recall Campaign 18V-735 (Ford Recall 18S32) regarding a defective Canister Purge Valve (CPV) that causes fuel vapor saturation, excessive fuel tank vacuum, fuel tank deformation, and engine stalling.The vehicle presented with an active check engine light for diagnostic trouble code P0420 (Catalyst System Efficiency Below Threshold). Ford technical service instructions under Recall 18S32 explicitly link code P0420 to a stuck-open CPV dumping unmetered fuel vapors into the exhaust stream. The franchised dealership initially performed only a software calibration without replacing the mechanical valve.Upon return, the dealership confirmed the defect and replaced the CPV under recall warranty at no charge on Repair Order # 872120. However, dealership service management refused to inspect the catalytic converter for secondary fuel-wash damage unless an unauthorized $220 customer diagnostic fee was paid. The technician cleared the diagnostic trouble codes in the stall without executing the required OBD-II drive cycle. Repair Order # 872120, Line C explicitly documents: "VEHICLE RELEASED FOLLOWING COMPLETION OF RECALL 18S32 WHERE…”

“The vehicle experienced a catastrophic failure of the canister purge valve (CPV), causing an excessive vacuum that violently deformed and collapsed the plastic fuel tank. The deformation was so severe that it breached the fuel system, causing raw gasoline to pour directly out of the filler area and onto the ground when fueling was attempted, presenting an immediate fire hazard. Furthermore, the structural collapse of the fuel tank pinched and shorted out the fuel pump electrical wiring harness. This short circuit caused a massive electrical spike that blew the high-amperage master mega-fuses located on the front of the battery box, causing a total loss of electrical power to the entire vehicle. The manufacturer's initial safety recall remedy (Recall 18S32) failed to prevent this dangerous recurrence, and the vehicle is currently at a dealership being evaluated under Customer Satisfaction Program 24N07.”

“Transmission overheated. Transmission fluid leaked but the computer in the car didn't let me know there was a leak. Couldn't move my car into reverse so I had to get a tow to Ford. They said it was a Transmission leak which caused the overheating. But once the car received Transmission fluid the car did not go into reverse. Clutch failed.”

“So I had check engine light I took it to the mechanic the code was p1450 the mechanic told me it’s the purge valve and it’s recall with ford book and appointment from the website witch is I did after I checked my vin I found out that’s this purge valve has recall and it’s free of charge I went to dealer they denied and said they have to do their diagnostic that will cost 190$ and they did not accept the car”

“Ford Motor issued two safety recalls regarding this, but has since closed them without providing a safe resolution for consumers. July 8 2019 Ford issued Ford Safety Recall program 19S22 (following 18S32) for stuck open canister purge valve (CPV). This can result in a failure to bleed the vacuum from the gas tank, and deforms the gas tank upon failure. This has been confirmed, reproduced, and recalled by Ford before, but continues to happen nationwide to Ford Focus ST owners as a small subset of their vehicles. A stuck open CPV can result in a number of codes. In my case, I got a P1450, Ford-Specific check engine light on the MIL. This can cause inability to start, along with rough idle and stalling while driving. Ford reports closing these safety recalls and provides no further support for the issue.”