2019 Jeep Cherokee engine problems

“I was coming out of a gas station and the battery light came on/ stayed on and the car just stopped. I couldn’t shut it off, put it in drive, put it in park…….The car still seemed to be running… I had to wait about 10 mins before I could do anything I.e. start it up again. This was very scary and unsafe as the car stopped dead between a street entrance/ exit of the gas station, and cars had to swerve to get around me.”

“So I was driving down the road doing 60 miles an hour and I have lost power total drive power while driving doing 60 miles an hour with a car just goes into a neutral rubs up and I have to pull on side of the road and turn off the car wait like 10 to 15 minutes and then the car resets itself I believe my car has a recall for the PTU and I believe that’s what’s wrong with it. It’s a recall so it needs looked at and I took it to the dealership saying my concerns and they have told me that there is no fix available yet for it which that cannot be true because I got something in the mail saying that there is a fix available so I’m not sure if they just don’t wanna do it cause it’s gonna be a hard job to do but it needs done ASAP because that’s putting my life in danger just having total loss drive power while driving down the highway doing 65 to 70 miles an hour it has happened three total times now.”

“On September 14, 2025, while driving on the highway, the vehicle began shaking violently, the check engine light illuminated and began flashing, and the vehicle progressively lost power and became undriveable. The vehicle had to be towed. No warning lights appeared prior to the incident. This failure follows a documented history of Power Transfer Unit (PTU) issues. In May 2024 at approximately 88,000 miles, diagnostic codes including C14A7-97 (PTU Motor - Component/System Blocked) were retrieved at an independent service center. The 4-wheel drive system was found to be stuck engaged. The transfer case actuator motor was replaced in December 2024 at approximately 93,000 miles by the same shop at my expense. The vehicle is a single-speed PTU configuration and was excluded from Equipment Safety Recall 02C (Two Speed PTU Failure), despite experiencing substantially similar symptoms: loss of drive power, vibration, and drivetrain malfunction. The PTU and transfer case are available for inspection. The failure has been confirmed by an independent service center. Prior to the highway failure, the vehicle exhibited difficulty accelerating, particularly at highway…”

“I am filing this safety complaint regarding my 2019 Jeep Cherokee Latitude Plus 2.4L AWD. This vehicle is experiencing severe, life-threatening safety hazards involving sudden engine stalling and a complete loss of motive power while in motion. Despite my vehicle exhibiting the exact failure symptoms of multiple major FCA/Stellantis safety recalls for this model year, my specific VIN is currently showing as excluded from the recall database, leaving me with a highly dangerous vehicle and no dealership remedy.The vehicle is suffering from two distinct, interrelated defects that have recently caused terrifying incidents in heavy traffic. First, while driving, the dashboard suddenly illuminated both the "SVC 4WD" (Service 4WD) and the "Auto Start-Stop" warning lights simultaneously. Immediately following these warnings, the vehicle lost forward power and unexpectedly rolled forward while I was fully stopped at a red light, failing to hold its position. This mirrors the exact mechanical behavior of the known Jeep PTU spline-wear defects that cause sudden rollaways and a loss of drive power.Second, the vehicle completely stalled out and shut down while I was driving…”

“The motor experiences a malfunction, which the passengers feel as a slight ‘bump’ in the engine. The dash flashes Service Electronic Stability Control and the engine experiences a loss in power followed by a gain in power, experienced as slight lurching. The dash ESC icon lights up yellow simultaneously as the ESC button on the center dash instrument cluster. The vehicle continuously lurches as it tries to stabilize, at this point the most ginger touch to the accelerator is necessary, otherwise the engine may stall out. I have been left stalled in the middle of a road where there was moving traffic passing by both ways. The mechanic said the engine codes read- P0340- Camshaft Position Sensor B1S1 & U1428- Received Engine Torque request signal stuck.”

“Plastic manifold cover has developed a hairline crack and is leaking oil. Vehicle has only 68,000 miles. Mechanic advised there is a national backorder of replacement manifold covers so up to the mercy of the manufacturer to produce more. From what I've seen online, this is a notorious issue with many different Jeep models over many years.”