2014 Jeep Grand Cherokee electrical system problems

“the transmission/clunks when starting, wile climbing hill wont engage loud crack when turning out of driveway right mirror wont engage when car is near the warning or the beeping wont go off climate control door wont move backup camera goes out / electrical system bugs also, repaired suspension system axle assembly front steering rack penion motor mount left side suspension control arm tpms sensor”

“The contact owns a 2014 Jeep Grand Cherokee. The contact stated that after starting the vehicle, the instrument cluster went blank and failed to display the speedometer or fuel gauge. The contact parked and turned off the vehicle. The contact stated that before the failure the battery was recharged due to the vehicle not being driven daily. The contact associated the failure with NHTSA Campaign Number: 13V483000 (Service Brakes, Hydraulic, Electrical System, Electronic Stability Control); however, the VIN was not included in the recall. The failure mileage was approximately 172,600.”

“While maneuvering in a parking garage and switching between reverse and forward, the engine suddenly and unprompted revved excessively, sounding as though the accelerator pedal was floored. The vehicle forcefully lunged forward against braking pressure into a cement wall, causing front-end damage to the vehicle. Cruise control was completely disabled and no check engine light or warning indicators illuminated on the dashboard. At no time did I feel like I had control over the car. I sustained some contusions. No one was in the vicinity at the time; however, other cars and/or people could have been struck. The vehicle has yet to be examined by anyone although I am in the process of arranging for an autobody repair shop. Prior to this, the car was in its usual state of health without any issues.”

“The vehicle has a severe, life-threatening safety defect where it randomly drops into neutral while driving at speed, physically locks the shifter, and actively engages the electronic braking system on its own, stranding me in active traffic. I brought the vehicle to a certified Jeep dealership to resolve this exact symptom. They misdiagnosed the vehicle and charged me nearly $3,000 to replace the valve body and connectors. The dangerous symptom remains completely unchanged, meaning the vehicle is unsafe to operate and the manufacturer-certified repair facility has failed to remedy a critical safety defect. The issue hasn’t been fixed and it has been 5-6 months.”

“My 2014 Jeep Grand Cherokee suddenly developed a no-start condition after previously operating normally. The vehicle would crank but would not start. The battery and fuel injectors were checked and replaced as needed, but the problem persisted. Based on the symptoms and known issues affecting 2011-2014 Jeep Grand Cherokees, the internal fuel pump relay/TIPM is suspected. This defect has been the subject of previous safety recalls because it can cause engine stalling or a no-start condition. Although my vehicle is not currently included in an open recall, it is experiencing the same type of failure. A failure of the fuel pump relay can leave a vehicle stranded or cause the engine to stall unexpectedly, creating a serious safety hazard if it occurs while driving. I believe this issue should be investigated to determine whether additional vehicles should be covered by the recall.”

“My Son just bought the car from a private party. On our way home the engine light and a lightning bolt icon illuminated on the dash, followed by the vehicle going into limp mode. We had the vehicle scanned for codes and it came back with P0336 (crankshaft position sensor performance). After much investigation online, we found out that this is a known issue with the crankshaft position sensor and, most importantly, the tone wheel on the back of the engine. We looked up recalls on the vehicle and found a safety recall had been issued. While some vehicles affected received replacement of the tone wheel and sensor, others just received a software update. This particular vehicle received the software update. The issue is that the magnetic material on the tone wheel delaminates from the tone wheel. This is a costly repair that should have been fixed correctly from the beginning, not just a software patch. It is a safety concern because it is dangerous when you are traveling at highway speeds and it goes into limp mode.”