2017 Jeep WranglerRecalls, problems, MPG & safety

“The ABS warning light remains illuminated and the vehicle is displaying diagnostic trouble code C2200, indicating an internal failure involving the Anti-Lock Brake System (ABS) control module. I am concerned that this is a safety-related defect rather than normal wear. I have found multiple reports from other owners of 2017 Jeep Wranglers describing the same or substantially similar failure involving C2200, ABS module failure, and illumination of the ABS/traction-control warning lights. Owners have also reported difficulty obtaining replacement OEM ABS modules due to extended backorders or lack of availability. Because the ABS module is part of the vehicle’s braking and electronic stability-control system, I am concerned about operating the vehicle without these safety systems functioning properly. I am requesting that NHTSA review the pattern of ABS control-module failures involving 2017 Jeep Wranglers and determine whether further investigation or a safety recall is warranted.”

“The first time happening I was driving on the interstate going about 70 miles an hour in the dark, the car completely shut down with no warning I was able to coast then tried to restart the vehicle and it started. I was able to get off the road and to my destination. The second time this happened, it was 5am in the morning getting on the interstate going about 40 miles an hour I got to the end of the ramp and merged into traffic again no warning the car shut down. This time the vehicle would not restart. I was able to coast to the shoulder with traffic approaching on me. Had to wait for a tow in the dark by myself.”

“The contact owns a 2017 Jeep Wrangler. The contact stated that while driving approximately 30-45 MPH, the vehicle lost power. On another occasion, while driving at 20 MPH, the vehicle lost motive power. While shifting into gear, the vehicle failed to respond as intended. The check engine warning light illuminated after the failure. The driver was able to pull over safely. The vehicle was running, and the heat was functioning. The vehicle was towed to a AAA Service Center, where the filter and oil were changed; however, the failure reoccurred. The vehicle was towed to AAA again, but no assistance was provided. The vehicle was taken to the local dealer, where it was diagnosed, and it was determined that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 100,000.”