2014 MINI Cooper problems

“Engine motor mount sheared, allowing motor to interact with and bounce directly on the frame, and stressing the other connections and components. Dealer indicated this is a very common problem for this car model and is likely a design issue, and even had another example of a sheared mount on display in order to show others with the same issue.”

“The contact owns a 2014 Mini Cooper. The contact stated that the front driver's side and passenger’s side doors and windows failed to properly close. The vehicle was taken to the local mechanic who diagnosed the vehicle and determined that the failure was caused by a faulty foot well module which caused the electrical power windows to malfunction and the doors to not properly close. The vehicle was not yet repaired. The manufacturer and local dealer were notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in NHTSA Campaign Number: 23V337000 (ELECTRICAL SYSTEM). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 80,000.”

“The fuse box JBE module has a Quality Assurance problem with a solder connection to the NEC low pressure fuel relay. This is a known issue with BMW/Mini. The car suddenly stalls without warning. If the driver is not keen or if traffic patterns do not allow, the car can be left in very dangerous situations on the highway or in the middle of intersection. The repair for this problem is widely distributed online via blogs and YouTube, but replacement modules are $1500 (part only) and these modules are not available until at least October 2023. There are no warning lights or other warnings prior to the incident. While I am not aware of any serious injuries, it is only a matter of time before someone is t-boned at an intersections. This part MUST be immediately recalled due to the safety risk. The images below show the JBE fuse box housing as well as the PCB where the cold solder joint can be seen. I have circled the cold solder joint in the close up picture.”

“TL* THE CONTACT OWNS A 2014 MINI COOPER. THE CONTACT STATED THAT THE RECALL NOTICE FOR NHTSA CAMPAIGN NUMBER: 14V815000 (STRUCTURE) WAS RECEIVED IN FEBRUARY OF 2015. AFTER CONTACTING THE DEALER AND THE MANUFACTURER ON MULTIPLE OCCASIONS, THE CONTACT WAS INFORMED THAT THE PARTS NEEDED TO REPAIR THE VEHICLE WERE STILL NOT AVAILABLE AND NO ESTIMATED TIME FOR RECEIVING THE PARTS COULD BE PROVIDED. THE CONTACT HAD NOT EXPERIENCED A FAILURE.”

“MY CAR WOULD MAKE A NOISE AT THE REAR OF THE CAR WHEN I DROVE ON A BUMPY STREET, I TOOK THE CAR TO THE DEALER AND AFTER THERE INSPECTION , THEY SAID THE REAR SWAY BAR LINKS HAD TO BE REPLACED. I AM CONCERNED THAT IF THE ORIGINAL PARTS WERE DEFECTIVE, MAYBE THE NEW PARTS WILL ALSO BE DEFECTIVE... THE CAR IS UNDER WARRANTY, THE DEALER IS MAKING THE REPAIRS...UPDATED 10/15/15 *BF THE DEALER STATED THE REAR SWAY BAR LINK WAS NOT THE PROBLEM CAUSING THE NOISE. UPDATED 10/20/15 *JB”

“NEARLY RAN OUT OF GASOLINE BECAUSE THE GAS GAUGE IS NOT ACCURATE. AT AN INDICATED 1/2 FULL, THE CAR IS DOWN OVER 9 GALLONS AND THE TANK HOLD ABOUT 12.5 GALLONS. USING THE GAS GAUGE THERE IS NO WAY TO TELL HOW MUCH FUEL REMAINS IN THE TANK. *TR”