2017 Ford Fusion EnergiRecalls, problems, MPG & safety

“I lost power while on the Freeway any indicators flashed: "see manual", "pre-collision assist not available", "service advance track", "downhill assist not available", the check engine light was on. It seems that when to limp mode. I took it to the Ford fusion dealer so they could check the car. They run into test and found that the transmission or motor has failed. I check and found that on that year make and model some cars were affected and it was a recall for that. This is the recall If the torque converter weld studs fail, the torque converter will not be connected to the engine flexplate and the vehicle will lose the ability to move, increasing the risk of a crash.”

“The contact owns a 2017 Ford Fusion. The contact stated that upon reversing out of the driveway and attempting to shift to drive(D), the message "System Fault - Consult Manual" was displayed. The contact was not able to shift to drive(D). The contact looked underneath the vehicle and noticed that the shifter cable was loosened. The contact was able to insert a screwdriver into the end of the cable, and the contact was able to shift to drive(D). The contact drove to the residence. The vehicle was taken to a dealer, where it was diagnosed and determined that the shifter cable bushing had failed and needed to be replaced. The vehicle was not repaired. The contact related the failure to an undisclosed recall however, the model year was not included. The dealer confirmed that the vehicle was not covered. The manufacturer was informed of the failure and referred the contact the NHTSA Hotline for assistance. The failure mileage was approximately 150,000.”

“The contact owns a 2017 Ford Fusion. The contact stated that upon starting the vehicle, the engine experienced a rough start and idling, and the check engine warning light was illuminated. The vehicle was taken to a local dealer where it was diagnosed, and the contact was advised that the engine was faulty due to coolant intrusion. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 90,000.”