2007 Jeep Grand Cherokee problems

“The contact owns a 2007 Jeep Grand Cherokee. The contact stated after the ignition switch was replaced under NHTSA Campaign Number: 14V438000 (Electrical System), the vehicle started making an abnormally loud sound at startup. The vehicle was taken to Auto Zone; however, no diagnostic trouble code was retrieved. The vehicle not diagnosed or repaired. The dealer and the manufacturer were notified of the failure. The failure mileage was approximately 192,000.”

“SOMETIMES WHEN I PUT MY VEHICLE IN DRIVE AND START DRIVING MY VEHICLE WILL GO INTO NEUTRAL FORCING ME TO PULL OVER, PUT IT IN PARK AND TURN IT OFF AND TURN IT BACK ON IN ORDER FOR ME TO DRIVE IT AGAIN. THIS HAPPENS ABOUT TWICE A MONTH.”

“The contact owns a 2007 Jeep Grand Cherokee. The contact stated that while driving at approximately 40 MPH and exiting an expressway, the vehicle stalled while the brake pedal was depressed to decelerate. The contact shifted into Neutral (N), and the engine was restarted to resume driving. Less than 5 miles later, the failure recurred while making a right turn. The vehicle was taken to an independent mechanic, who diagnosed a failed throttle body and replaced the component. Following the repair, the failure persisted and increased in frequency, occurring while decelerating or coming to a complete stop. The dealer was contacted and confirmed that the VIN was not included in a recall. The failure mileage was 124,981.”

“I BOUGHT A USED 2007 JEEP GRAND CHEROKEE 2 YEARS AGO IN ALABAMA. WE HAVE SINCE MOVED TO NEW YORK STATE AND THEY DO VEHICLE INSPECTIONS (ALABAMA DOES NOT). WHEN GETTING THE VEHICLE INSPECTED IT WAS DISCOVERED THAT THE CUT OUT FOR THE CHECK ENGINE LIGHT ON THE INSTRUMENT PANEL IS NON EXISTENT. ALL OTHER CUT OUTS ARE PRESENT AND THE LED FOR THE CHECK ENGINE LIGHT IS PRESENT AND WORKING. THE INSTRUMENT PANEL IS STAMPED AS BEING ORIGINAL AND NOT AFTERMARKET. BECAUSE THERE IS NOT A CUT OUT THE LED FOR THE CHECK ENGINE LIGHT IS NOT VISIBLE WITH THE INSTRUMENT PANEL INSTALLED AND WILL NOT PASS INSPECTION. I HAVE CONTACTED MY LOCAL JEEP DEALERSHIP (FX CAPRARA) AND THEY TOLD ME TODAY THAT I HAVE TO PAY TO FIX IT. A NEW PANEL BEING $600 AND A USED PANEL FROM MY LOCAL PICK AND PULL BEING $125. I CALLED JEEP CUSTOMER SERVICE TODAY AND THEY AGAIN TOLD ME JEEP CAN'T DO ANYTHING AND THAT IT IS UP TO THE DEALERSHIPS. I DON'T UNDERSTAND WHY IT WOULD BE UP TO ME TO PAY FOR THIS. IT IS A MANUFACTURER DEFECT AND SHOULD BE CORRECTED ON THAT LEVEL. I DID MY DUE DILIGENCE WHEN PURCHASING THE CAR BUT ONE CANNOT BE EXPECTED TO PULL THE DASH PANEL TO ENSURE ALL THE CUT OUTS ARE PRESENT.…”

“ENGINE STALLS NO MATTER WHAT SPEED I'M GOING. HAPPENS MORE OFTEN WHEN COMING TO A STOP. IT'S AS IF I JUST TURN THE KEY OFF. WHEN IT STALLS, I STOP AND PUT IT IN PARK, TURN THE KEY OFF AND START IT RIGHT BACK UP AND TAKE OFF. IT'S BECOMING A DANGEROUS SAFETY CONCERN.”

“THE HEAT OF THE SUMMER MONTHS TEND TO MAKE THE CAR ENGINE SPUTTER AS YOU HEAD DOWN THE ROAD. THIS HAPPPENED AGAIN YESTERDAY ONLY THIS TIME AS WE PREPARED TO MAKE OUR TURN THE VEHICLE TOTALLY SHUT OFF, ALLOWING ME TO LOOSE CONTROL OF THE STEERING WE WERE FORTUNATE NO ONE WAS BEHIND US OR PULLING OUT WHERE WE WERE TURNING . WE WOULD HAVE EITHER BEEN REAR ENDED OR WOULD HAVE RUN INTO ANY CAR WAITING TO TURN.”